CASASCAPES
ECO SEAL LOW GLOSS + COLOR ENHANCER

ECO SEAL LOW GLOSS + COLOR ENHANCER

CasaScapes Eco Seal Low Gloss + Color Enhancer is acrylic copolymer used to seal concrete pavers. It penetrates deep into the concrete paver pores, thus reducing the oil and dirt penetration, as well as protecting them from the corrosion of de-icing salt.

Technical Data Sheet

Features

  • Helps resist corrosion from de-icing salt, ultraviolet rays effects, motor oil and grease stains
  • Works above 40ºF (5ºC)
  • Breathable
  • Film former
  • Joint stabilizer
  • Will not discolor
  • Rapid Installation
  • Low VOC
  • Color enhancer

Helps Resist

  • Corrosion from De-Icing Salt
  • Ultraviolet Ray Effects.
  • Motor Oil & Grease Stains.

Ideal For

  • Natural stones
  • Concrete & clay products

INSTRUCTIONS

See videos for visual installation. Always refer to the latest CasaScapes Eco Seal Low Gloss + Color Enhancer
Technical Data Sheet (TDS) before installation.

  • Can be used as a stand alone sealer. Apply at the rate of 200 sq. ft. (18.5 sq. m.) per gallon. Spray on the surface and back roll if needed to even out the surface.
  • Can be used as a Sealer/Joint Sand Stabilizer w/ ASTM C144 Sand. Apply at the rate of 100 sq. ft. (9.3 sq. m.) per gallon, then force the excess sealer from the surface into the joints using a squeegee or roller.
  • Concrete pavers should only be sealed 60 days after their installation date. Consult concrete paver manufacturer’s for their recommendation.
  • ALWAYS TEST the product on a small hidden area of approximately 4 sq.ft. (0.4 m2) to ensure the results will meet your expectations.
  • Clean the entire surface with the Gator Clean Efflorescence Cleaner. This product will remove the efflorescence trapped in the concrete paver pores, as well as thoroughly clean the surface for proper sealer adhesion.
  • Do not apply if rain is expected within 24 hours.
  • Do not allow sealer to puddle.
  • Temperature should be between 40°F (5°C) and 85°F (29°C) when sealer is applied.
  • Concrete paver surface must be cool to the touch when sealer is applied (between 40°F (5°C) and 85°F (29°C)).
  • CasaScapes Eco Seal is water repellant, rain safe, after 24 hours.
  • Let the sealer dry for 24 hours before using the sealed area.
  • Wear protective gloves, eye protection and respiratory protection.

Alliance Designer Products shall not be liable for any non-compliant use, unless the manufacturer, distributor, or seller knows that the supplied coating would be used in a noncompliant manner.

* The container must at all times be stored at above 32°F (0°C) to receive the benefit under the Limited Warranty.

Coating Category: Waterproofing Concrete/Masonry Sealers. VOC Concentration Limits: <100 g/L (grams of VOC per liter of coating, less water and less exempt compounds). SCAQMD compliant.